Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
9) Glass glue should be applied immediately after installation: use non-acid glass glue, be sure to use special glass glue for atomized glass.
Circuit installation:
1) All related circuits of the atomized glass wiring must be installed by a qualified electrical engineer, or the manufacturer's personnel must be instructed on site.
2) Before installation, you must carefully check the exposed electrode pads, whether the electrodes and wires are in contact with the metal frame, so as not to damage the power supply and the dimming glass. Electrodes and wires exposed during the gluing process or transportation can be covered with insulating tape.
3) First make sure that the power is not turned on. Before installing the dimming glass, make sure that there are outlet holes or slots on the frame.
4) Before installation, check whether the electrode position of each piece of glass is well sealed, and confirm that no sealant has fallen off.
5) The electrode wire on the glass is not allowed to be directly connected to 220V, and the electrode wire of the dimming glass is connected to the power output terminal AC70V or 60V. Multiple pieces of dimming glass should be connected in parallel at the output end of the power supply
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.